Use: Three sockets with different directions (such as 45° and 90°) are used for complex pipeline turning.

Installation steps:

Position the tee according to the designed angle and mark the length of each pipe section.
Glue the three sockets in sequence (curing in order: install the two ends first, and then install the middle branch).

General installation specifications

Environmental requirements:

- Construction at temperature ＞5℃ (adhesive fails at low temperature).

- There is no water or oil in the pipeline (cleanliness affects bonding strength).

Gluing operation:

- Apply glue evenly and quickly (complete plug-in within 30 seconds), and the curing time is ≥30 minutes (≥24 hours before pressure).

Pressure test:

- After installation, a hydrostatic pressure test of 1.5 times the working pressure is required (pressure stabilization ≥30 minutes).

Safety protection:

- When UPVC is used for chemicals, confirm the corrosion resistance (refer to the chemical compatibility table). - The blind plate must be depressurized before removal to avoid splashing of high-pressure liquid.